The Scotch Cast repair kit provides maximum protection for the electrical wiring repairs and moisture proofing for direct burial electrical cable. More about Repairing Direct Burial Electrical Cables The circuit should be turned OFF until the condition has been resolved.Open splices such as this should be repaired right away to eliminate a potential shock hazard!.The buried cables should be checked to see if they are properly rated for Direct Burial and the cables should be buried a minimum of 24 inches deep.The concrete box may be placed over the splices after the splices have been made.The splices should be accessible as well which could be accomplished by installing a concrete box, such as a Christy Box with a concrete lid or a traffic rated lid if this is in a traffic area.The direct burial splices must be made properly using a corrosion inhibitor and then well insulated.Protection for Buried Electrical Cable Splices Special Materials: Depending on the final enclosure to protect the splices, Moisture proof or Water Resistant Materials including Properly sized wire connectors, anti-corrosion ointment, electrical tape, shrink tubing or other materials to perform an approved splice method. Precaution: Identify the affected power source, turn it OFF and then Tag it with a Note before performing any wire splicing or cable repairs. Tools Required: Basic Electricians Pouch Hand Tools and Voltage Tester Ground or Trenching Hand Tools.Įstimated Time: Depends on the personal level experience and ability to work with tools, condition of the soil or environment for access to the cable or electrical wiring. Skill Level: Intermediate to Advanced – Best performed by a Licensed Electrical Contractor. Splice Direct Buried Electric CablesĪpplication: Splicing Underground or Direct Buried Electrical Cables. Thanks for your Electrical Repair question Ray. This home electrical repairs question came from: Ray, from Milton, Florida. My question is how can this be made safe? Is there some way to cover the bare spliced wires and lugs to prevent any kind of short since they are all three buried close to each other?.When uncovering them next to the house I found that all three cables have been spliced in the same location.The problem is that the #2 wires are direct buried cables.I have a 200 Amp panel with a 100 Amp breaker which has three #2 gauge wires running to a secondary electric service box.I am working with a electrical service panel that feeds another service panel.For help with product selection and use, consult your on-site safety professional, industrial hygienist, or other subject matter expert.Electrical Question: Is there a way to cover spliced wires and lugs to prevent damage? Misuse of 3M industrial and occupational products may result in injury, sickness, death, or property damage. OSHA, ANSI), as well as all product literature, user instructions, warnings, and other limitations, and the user must take any action required under any recall, field action, or other product use notice.

Unless specifically stated otherwise on the applicable product packaging or literature, these products are not intended, labeled, or packaged for sale to or use by consumers (e.g., for home, personal, primary or secondary school, recreational/sporting, or other uses not described in the applicable product packaging or literature), and must be selected and used in compliance with applicable health and safety regulations and standards (e.g., U.S. Not for consumer sale or use.ģM industrial and occupational products are intended, labeled, and packaged for sale to trained industrial and occupational customers for workplace use. Contact customer service at 80 to request a certificate.

Note: 3M products offered on a government contract that require country of origin representation must be certified by 3M Trade Compliance. Some products contain imported components.

The designation that a product is Manufactured in the USA means the product undergoes substantial transformation in one of our U.S.

Direct bury wire connectors